[FieldTrip] downsampling CTF data prior to ft_preprocessing

Stan van Pelt stan.vanpelt at fcdonders.ru.nl
Thu Jan 16 13:30:30 CET 2014


Hi Frederic,

You might be able to do that with CTF software, most likely DataEditor.

Best,
Stan

-----Original Message-----
From: fieldtrip-bounces at science.ru.nl
[mailto:fieldtrip-bounces at science.ru.nl] On Behalf Of Eelke Spaak
Sent: donderdag 16 januari 2014 13:16
To: FieldTrip discussion list
Subject: Re: [FieldTrip] downsampling CTF data prior to ft_preprocessing

Hi Fred,

What about ft_resampledata? This is of course applied only after reading
it in, but I'm not sure if it matters.

Best,
Eelke

On 16 January 2014 13:00, Frédéric Roux <f.roux at bcbl.eu> wrote:
> Dear all,
>
> does anyone know of a good method to downsample MEG-data acquired with
> a CTF system before reading it into Matlab/fieldtrip.
>
> I remember that there is a command-line tool provided by CTF which can
> do preprocessing, but I don't remember exactly if it does the job.
>
> Or does anyone know of a good alternative solution?
>
> Best,
> Fred
>
> _______________________________________________
> fieldtrip mailing list
> fieldtrip at donders.ru.nl
> http://mailman.science.ru.nl/mailman/listinfo/fieldtrip

_______________________________________________
fieldtrip mailing list
fieldtrip at donders.ru.nl
http://mailman.science.ru.nl/mailman/listinfo/fieldtrip



More information about the fieldtrip mailing list