[FieldTrip] Address of biosemi device

[Hamza Fawzi Altakroury (Student)]

Thank you Boris.

Well, I tried the default mode (just by specifying the configuration file
and the gdf file in the cmd). But this message appeared.
Could you or anyone just tell me exactly what should I do or modify.

Thanks a lot

On Wed, Dec 21, 2011 at 12:56 PM, Boris Reuderink <b.reuderink at donders.ru.nl
> wrote:

> Dear Hamza,
>
> I think this message appears when you specify a specific buffer server
> to connect to. The biosemi2ft.exe can be run in two modes, 1) it
> starts an baked-in buffer server (default), or 2) it can can use a
> buffer server that is run in a separate process.
>
> The default mode is probably a good choice. You can select the default
> mode *by not specifying a server of port*.
>
> Best regards,
>
> Boris
>
> On Mon, Dec 19, 2011 at 10:03 AM, Hamza Fawzi Altakroury (Student)
> <hamzaf at sabanciuniv.edu> wrote:
> > Hello,
> >
> > I'd tried to use the biosemi2ft function for realtime acquiring. But the
> > following message appears:
> >
> > "Could not connect to buffer server at localhost: 1972".
> >
> > Should I change the Hostname and the Port, if yes what should they be?
> >
> > Best,
> >
> >
> > --
> > Hamza Fawzi Altakroury
> > Graduate student - MA
> > Faculty of Engineering and Natural Sciences
> > Sabancı University
> >
> > _______________________________________________
> > fieldtrip mailing list
> > fieldtrip at donders.ru.nl
> > http://mailman.science.ru.nl/mailman/listinfo/fieldtrip
>
> _______________________________________________
> fieldtrip mailing list
> fieldtrip at donders.ru.nl
> http://mailman.science.ru.nl/mailman/listinfo/fieldtrip




-- 
Hamza Fawzi Altakroury
Graduate student - MA
Faculty of Engineering and Natural Sciences
Sabancı University
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://mailman.science.ru.nl/pipermail/fieldtrip/attachments/20111221/e06efb70/attachment-0002.html>