[FieldTrip] Source reconstructions

[Eelke Spaak]

Ah sorry, I was getting your previous replies with a delay. If 'mm'
makes them even smaller, perhaps 'm' is the right unit? In any case, I
very strongly suspect that a spatial unit mismatch is the cause of the
discrepancy you're seeing.

Cheers,
Eelke

On Mon, 14 Jan 2019 at 11:54, Eelke Spaak <e.spaak at donders.ru.nl> wrote:
>
> Perhaps a stupid question but have you also tried sens =
> ft_convert_units(sens, 'mm')?
>
> Eelke
>
>
> On Mon, 14 Jan 2019 at 10:52, Elene Beitia Loinaz
> <elene.beitia at alumni.mondragon.edu> wrote:
> >
> > Dear fieldtripers,
> >
> > I am tryng to visualize the electrodes and the headmodel at the same time. The problem that I have is that I need to reescale one of them.
> >
> > I have tried to function ft_convert_units, but I just obtain the image attached.
> >
> > The structure of the information are the next ones,
> > headmodel:
> >      bnd: [1×3 struct]
> >      cond: [0.3300 0.0041 0.3300]
> >      mat: [3000×3000 double]
> >      type: 'dipoli'
> >      unit: 'mm'
> > electrodes:
> >       pnt: [133×3 double]
> >       label: {1×133 cell}
> >
> > Code that I have used to obtained the image below:
> > ft_determine_coordsys (vol, 'interactive','no')
> >
> >
> > figure;
> > sens=data.elec;
> > sens=ft_convert_units(sens, 'cm');
> > ft_plot_vol(vol,'facecolor','skin','edgecolor','none')
> > ft_plot_sens(sens,'elecsize',10)
> > camlight
> > alpha 0.5
> >
> > If somebody could help my I would be very grateful,
> >
> > Elene
> >
> >
> >
> > _______________________________________________
> > fieldtrip mailing list
> > https://mailman.science.ru.nl/mailman/listinfo/fieldtrip
> > https://doi.org/10.1371/journal.pcbi.1002202