[FieldTrip] Automatic artifact detection (no rejection)

[Philipp Taesler]

Hi Robin,

you might be interested in the section "Negative trialpadding" in the
rejection tutorial at

http://www.fieldtriptoolbox.org/tutorial/automatic_artifact_rejection

Otherwise, you can just pass the structure containing the artifact info
from automatic detection (cfg.artfctdef.xxx) to ft_databrowser. This way
you can screen the data and manually define and/or remove artifacts from
the trials.

Cheers,
Phil



Am 01.07.2016 um 11:53 schrieb Robin Kramer:
> Hi all,
> 
> I want to use automatic artifact detection to easily find the trials
> where range-thresholds may be exceeded. However, because the segments
> are a little larger than the time of interest (for baseline correction
> a.o.), I do not always want to remove all the trials where the threshold
> is exceeded. Is there a way to deselect the automatically detected
> artifacts? 
> 
> Best,
> 
> Robin Kramer

-- 
Philipp Taesler
Department of Systems Neuroscience
University Medical Center Hamburg-Eppendorf
Martinistr. 52, W34, 20248 Hamburg, Germany

Phone: +49-40-7410-59902
Fax:   +49-40-7410-59955
Email: p.taesler at uke.de
--

_____________________________________________________________________

Universitätsklinikum Hamburg-Eppendorf; Körperschaft des öffentlichen Rechts; Gerichtsstand: Hamburg | www.uke.de
Vorstandsmitglieder: Prof. Dr. Burkhard Göke (Vorsitzender), Prof. Dr. Dr. Uwe Koch-Gromus, Joachim Prölß, Rainer Schoppik
_____________________________________________________________________

SAVE PAPER - THINK BEFORE PRINTING