data conversion

[Thomas Thesen]

Thank you Eric.

Where did you get the NAN_SUM function from? A specific toolbox other than
the Stats toolbox? In April you made revision 1.5 to CLUSTERRANDSTATISTICS
and included NAN_SUM.
I'm running matlab6 & 7 with the Stats toolbox and don't have this function.
Looking online I couldn't find anything about NAN_SUM either. However, there
is NANSUM, but replacing it in CLUSTERRANDSTATISTIC produces an error. Do
you have any suggestions?

cheers,
Thomas

On Thu, 26 May 2005 11:03:16 +0200, Eric Maris <maris at NICI.RU.NL> wrote:

>Hi Thomas,
>
>
>> Hi Robert,
>> You said:
>>>It states "selected 151
>>>channels", but you mentioned that you have only one channel. In
>>>selecting a single channel to reduce the amount of data, did you also
>>>make the corresponding change in freq.label?
>>
>> How exactly do make the corresponding change to tell CLUSTERRANDANALYSIS
>> that there is only one  frequency channel to be analyzed? I assume I
>> change
>> something in the data structure, not in the cfg. setup, right? I tried to
>> change group_C4.sgn={'spec'} group_C4.label={'spec'} to have single
>> channel
>> name entries, but that didn't do the job.
>>
>> Thanks a lot,
>> Thomas
>
>If your data structure (containing the TFR) has a single frequency only
>(e.g., group_C4.sgn={'chan1'}), then you have to do nothing. If the data
>structure contains multiple channels (e.g., group_C4.sgn={'chan1','chan2'}),
>then you have to specify cfg.channel={'chan1'} if you want to analyze this
>channel only.
>
>
>
>Good luck,
>
>Eric Maris
>
>
>
>
>>
>>
>> On Wed, 25 May 2005 22:25:40 +0200, Robert Oostenveld
>> <r.oostenveld at FCDONDERS.RU.NL> wrote:
>>
>>>On 25 May 2005, at 11:18, Thomas Thesen wrote:
>>>
>>>> group_C4.sgn={'spec'}
>>>> group_C4.label={'spec'}
>>>>
>>>> but no success. Do you have any suggestion?
>>>
>>>Could you be more specific?
>>>
>>>Robert>