<div dir="ltr">Hi All,<div><br></div><div>I am currently struggling to fit dipoles to my auditory data. In short I want to 'turn off' half the channels (so I only have one hemisphere)  (as can easily be done in CTF tools DipoleFit). I thought this would be easy by having the timelocked data that went into ft_dipolefitting, have cfg.channel='MR' or 'ML'.</div>
<div>The issue I have is when I dipole fit this data, the dipole ends up in the center of the head. I definitely have only left or right channels selected (as checked in the output of ft_timelockanalysis). I thought of two ways around this. A) I use an initial guess away from the center of the head (with cfg.nonlinear ='yes') B) I have a source model with the medial - lateral space starting starting away from the center (e.g. in CTF coordinate Y = 2:1:7) [again with cfg.linear='yes']. While these approaches normally work, I have a particularly stubbon couple of datasets, that still think the the dipole is in the center of the head. When I check the topoplot of the date being fit, it appears that the 'turned off/not analyzed' side (the side not specified in ft_timelock analysis's cfg) is completely red on the topoplot, which would not be a problem but there is a small sink close to it, which is throwing off the dipole placement. Next I repeated my dipole fitting using my altered source model with cfg.nonlinear='no', but again this source and sink caused by the contralateral hemisphere is pulling the dipole to the edge of my source model space. Does anyone have any suggestions. When I try to dipole fitting this data in CTF DipoleFit I do not have this issue (presumably because the contralateral hemisphere is no contributing to the dipole fit).</div>
<div><br></div><div>Thanks</div><div>Russ</div></div>